semi bath oil это не моторная синтетика,и тот спец прав,моторное масло в вилку лить нельзя.
А в воздушную камеру по мануалу в дрейк масло лить не нужно.
---------- Добавлено в 12:29 ---------- Предыдущее сообщение было в 12:27 ----------
WARNING This fork uses compressed air to provide spring resistance and
must be relieved of pressure prior to servicing. Failure to relieve air pressure
could result in injury or possible death.
1. The casting needs to be removed prior to servicing the ACT
Air system. Refer to the Casting Removal section for
instructions on how to do this.
2. Release all air from the system by depressing the valve
core on the Schrader valve.
3. Using a 20mm socket or wrench remove the top air cap
assembly from the fork. (Fig. 1)
4. Remove the spring from the fork. (Fig. 2)
5. Using a 22mm wrench unthread the compression rod
assembly end cap and remove the assembly from the fork
uppers. (Fig. 3)
6. Replace the air piston o-ring on the compression rod
assembly. (Fig. 4)
7. Apply a small amount of grease to the o-ring and insert
compression rod assembly back into the fork uppers.
Tighten the end cap down to 9.0-11.3 Nm (80-100 in. lbs)
8. Grease the spring and place it into the fork uppers from the
top.
9. Install air cap. Tighten down to 6.8-9.0 Nm (60-80 in. lbs)
10. Using a shock pump, fill fork to desired air pressure.


Ответить с цитированием