SINUMERIK, ну вы и нижний заодно уж выньте, чтобы удостовериться.
Протрите, может и маркировка там на боковине будет.
---------- Добавлено в 16:58 ---------- Предыдущее сообщение было в 16:49 ----------
А по углам вы не подскажете?
Первый угол в маркировке, он к внутренней обойме относится?
Бывает нижнее опорное кольцо рулевой с углом отличным от 45 градусов?
Ну вроде разобрался.Я просто только обратил внимание что интегрированная рулевая у меня. Вот вроде верхний у меня 41.8 а нижний 52 .Думаю такой вот набор подойдет. https://www.avito.ru/krasnodar/velos...mah_1967307367
В интернете есть все!!! Надо только уметь искать
Бегемот
Это же так просто https://www.google.com/search?client...UTF-8&oe=UTF-8 )))
В интернете есть все!!! Надо только уметь искать
Бегемот
Действительно.
В двух статьях скопировано из одного источника:
"Используются "промы" только со скошенной нижней гранью подшипника, в частности встречаются варианты со скосом 45°-45°(Campy spec), или со скосом 36°/36° (Tien Hsin Ind./FSA Standard), или же со скосом 36°/45° (Cane Creek spec, только для стакана 1.1/8″)."
---------- Добавлено в 21:29 ---------- Предыдущее сообщение было в 21:02 ----------
Из Вики:
FSA Standard: 36/36. No one uses this standard for fully integrated headsets (bearing sitting in frame) except for a few niche brands. There are still a lot of 36/36 bearings as they are used in all FSA's semi-integrated (internal cup) headsets and some of their standard headsets as well.
А 36°/45° Cane Creek, это 36 у внутреннего кольца подша, а 45 у внешнего.
Но это для прямого стакана описалово, тока щас заметил:
It is important to distinguish different standards of cartridge bearings in Integrated 1⅛" headsets. There are three integrated standards which are not compatible with each other. The numbers (45/45, 36/45, 36/36) refer to the angle on the cartridge bearing they use. All these bearings look similar.
Не всё так просто, на самом деле.
ЗЫ. У Парк Тула:
The “IS” system is considered the most common. The name Integrated System is not a registered trade name. The system uses the 45-degree bearing contact in the frame. The bearings for the 1-1/8 inch steering columns use a 41mm outside diameter with a 45-degree bearing contact in the frame. The bearing may be marked “36-45.” The first number refers to the inside bearing contact with the headset race or centering cone. The second number refers to the frame contact.
The less common 36-degree angular contact standard uses a bearing for the 1-1/8 inch steering columns with a 41.5mm outside diameter. The bearings may be marked “36-36.” The IS frame standard of 36-degrees is now considered obsolete.
Последний раз редактировалось sergey_77; 07.11.2020 в 22:09.
Эту тему просматривают: 1 (пользователей: 0 , гостей: 1)